The system has 3 positions:
- disabled;
- low noise mode;
- maximum mode.
First, let's install additional fenestrons under the HDD.
To reduce noise, we attach the fenestrons to an elastic suspension.
![Adjustable computer cooling system](https://i.washerhouse.com/_nw/9/894-1.jpg)
I used rubber rings and guy wires (all in a hurry)
![](https://i.washerhouse.com/_nw/9/894-2.jpg)
To control the cooling, I had to ruin the front plug:
![](https://i.washerhouse.com/_nw/9/894-3.jpg)
![](https://i.washerhouse.com/_nw/9/894-4.jpg)
![](https://i.washerhouse.com/_nw/9/894-5.jpg)
Insert the switch into the holes made and Light-emitting diode to indicate the operating mode.
![](https://i.washerhouse.com/_nw/9/894-6.jpg)
Now about the filling.
![](https://i.washerhouse.com/_nw/9/894-7.jpg)
The diagram is presented in drawings and photos.
The circuit is not critical to the choice of radioelements:
- 1 kOhm resistors - any power (0.125 W mlt used);
- R load – a powerful resistor of at least 3 W (PEV-4 is used)
- Any diodes with a current of at least 0.5 A (1N4007 used)
- 2-position relay U power = 12 V (REK 23 (12V, 1A) was used)
- two-color Light-emitting diode.
![](https://i.washerhouse.com/_nw/9/894-8.jpg)
That's all.
The only thing you have to adjust is the high-noise mode voltage.
In our case, the system controls three fenestrons, an input (120 mm) and two blowers for hard drives (60 mm). It was experimentally found that at a voltage of 7 Volts the noise is not great and the performance is acceptable. A wire rheostat was used to set the voltage to 7 Volts when the fenestrons were operating - a resistance of 20 Ohms was obtained.
In your case, the load resistance R may have to be adjusted.
![](https://i.washerhouse.com/_nw/9/894-9.jpg)
Here's what happened:
![](https://i.washerhouse.com/_nw/9/894-10.jpg)
Switch Position:
0 - fenestrons are turned off (indicator color red);
I - low noise mode (indicator color yellow)
II - maximum mode (indicator color green)
![](https://i.washerhouse.com/_nw/9/894-11.jpg)
Author crafts: Ika_tander