What needs to be prepared?
- headband;
- red ribbon 5 cm wide;
- black thread;
- green ribbon (2.5 cm);
- felt mugs;
- blue ribbon (2.5 cm);
- stamens blue, white;
- white tape 6 mm;
- yellow ribbon 1 cm;
- viburnum in sugar;
- blue ribbon 2.5 cm;
- green tape 0.6, 2.5 cm, 4 cm;
- stamens.
Poppy
It is a luxurious bright red flower with large leaves and a box-shaped center. To make it, you need to cut the tape into squares with a side length of 5 cm.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1920-venok-iz-atlasnyh-lent.jpg)
Next, we cut out the petals with a round edge by eye. We process each petal over the flame and stretch it in different directions to create waves.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1921-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1922-venok-iz-atlasnyh-lent.jpg)
In total you need to make 8-10 petals. Take a felt circle and glue all the petals in a circle.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1925-venok-iz-atlasnyh-lent.jpg)
To make the middle, you need to take a little padding polyester or cotton wool, roll it into a ball and wrap it with a piece of green ribbon.Using a needle and thick black thread, we wrap the middle.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1923-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1924-venok-iz-atlasnyh-lent.jpg)
Next, we wind the thread on two fingers, tie it in the middle, and then cut the edges, comb them and glue them under the box.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1926-venok-iz-atlasnyh-lent.jpg)
This design needs to be glued to the center of the poppy.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1927-venok-iz-atlasnyh-lent.jpg)
We make several flowers, I have 3 of them. Cornflower For cornflower you need to cut the blue ribbon into 4 cm pieces.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1933-venok-iz-atlasnyh-lent.jpg)
Using a soldering iron, we make teeth on one edge of the tape. Next, use scissors to give the opposite edge the appearance of a petal.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1934-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1935-venok-iz-atlasnyh-lent.jpg)
We collect 20 petals on a thread and tighten them. Insert a bunch of blue stamens into the center. Glue a blue or black felt circle to the back of the flower.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1936-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1937-venok-iz-atlasnyh-lent.jpg)
Chamomile
For chamomile, cut a narrow ribbon 6 mm wide into 3.5 cm pieces.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1938-venok-iz-atlasnyh-lent.jpg)
One edge of the petal must be cut so that it is sharp and secured over the fire. Fold the second edge in half lengthwise and also secure it over the fire.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1939-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1943-venok-iz-atlasnyh-lent.jpg)
To make the middle, we sew a 1 cm wide ribbon and then tighten it to form an “accordion”. We roll it into a spiral and secure it with glue or a needle and thread.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1940-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1941-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1942-venok-iz-atlasnyh-lent.jpg)
We glue the petals on the base in a circle, their number is approximately 50 pieces, and glue the middle into the center.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1944-venok-iz-atlasnyh-lent.jpg)
Periwinkle For periwinkle you need to make round petals kanzashi from blue ribbon. After this, we pinch the edges of the petal with tweezers and burn it over a candle so that the petals become angular.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1928-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1929-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1930-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1931-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1932-venok-iz-atlasnyh-lent.jpg)
We glue 5 petals together and glue the stamens to the center. Glue 3 flowers together from the back side. Leaves You need to make leaves from various ribbons of green shades. To do this, fold an 8 cm piece of tape in half and cut it with a soldering iron or cut it with scissors and secure the cut over the fire.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1947-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1948-venok-iz-atlasnyh-lent.jpg)
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1945-venok-iz-atlasnyh-lent.jpg)
Assembling the wreath Take the rim and wrap it with green ribbon.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1946-venok-iz-atlasnyh-lent.jpg)
Next, glue the leaves onto the surface, making a bed for the flowers.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1949-venok-iz-atlasnyh-lent.jpg)
After this, we distribute the flowers on the surface. I glued a poppy in the middle, cornflowers and daisies were attached between the poppies, and periwinkle flowers were added.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1950-venok-iz-atlasnyh-lent.jpg)
Also, if desired, viburnum can be added to the wreath - for me these are ready-made berries in sugar.
![Satin ribbon wreath](https://i.washerhouse.com/images/19/1951-venok-iz-atlasnyh-lent.jpg)
The wreath is ready.