![Feeder feeders](https://i.washerhouse.com/images/9/1294-kormushki-dlya-fidera.jpg)
First of all, cut a strip from the bottle. We cut it in such a way that when rolled up, we get a cylinder with dimensions corresponding to the size of the feeder.
![Feeder feeders](https://i.washerhouse.com/images/9/1295-kormushki-dlya-fidera.jpg)
Next you need to make holes in the strip. This is easy to do with a heated soldering iron. If you don’t have one, a nail heated over a fire will do.
![Feeder feeders](https://i.washerhouse.com/images/9/1296-kormushki-dlya-fidera.jpg)
When heating it should be held with pliers, this will reduce the risk of burns. You need a lot of holes. The bait will spill out through them.
![Feeder feeders](https://i.washerhouse.com/images/9/1297-kormushki-dlya-fidera.jpg)
After this you will need a strip of lead. Lead is most easily found in old car batteries. One battery is enough for many feeders. But before use, the lead must be melted down.This should be done outdoors, taking all precautions. To obtain strips of lead, a piece of it is flattened with milk into a sheet and cut into the required strips with ordinary scissors.
![Feeder feeders](https://i.washerhouse.com/images/9/1298-kormushki-dlya-fidera.jpg)
The lead strip should be slightly longer than the feeder. This will secure it.
![Feeder feeders](https://i.washerhouse.com/images/9/1299-kormushki-dlya-fidera.jpg)
Bend the paperclip as shown in Figure 7.
![Feeder feeders](https://i.washerhouse.com/images/9/1300-kormushki-dlya-fidera.jpg)
After this, using pliers, we assemble the feeder. First, fold the edge of the strip without a paper clip. You need to press the lead as hard as possible. The homemade feeder feeder is ready.
![Feeder feeders](https://i.washerhouse.com/images/9/1301-kormushki-dlya-fidera.jpg)
If you have scales, the feeders can be weighed and labeled with a marker. It is not necessary to make the feeder transparent. You can use bottles of different colors.