![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082815_1525082737.jpg)
This is a very simple swing that can be done in an hour. They are great for children, are well adjustable in height, and do not contain expensive or scarce materials. Your children will be delighted with this design.
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082738_1.jpg)
The swing is hung on a branch or tree branch.
Making a swing
We take a car tire, be sure to have no studs. It’s even better if its protector is completely bald.
We take a drill and reduce it, say 10 mm. And through the same interval we make such holes. This will be the bottom of the swing, and these holes are needed to allow water to drain from the rain.
Everything that you see in the frame from the materials I used can be easily bought at any hardware or hardware store.
I needed three of these sets:
The tire in my design will be suspended on three supports. Therefore, on the other side, where there are no rain holes, drill 3 holes equally spaced from each other and insert such bolts with rings into the bottom. We tighten everything with a wrench.
We put S-shaped hooks on these rings.
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082819_8.jpg)
And we clamp them with special pliers.
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082795_11.jpg)
We do the same for the other two fasteners.
Next, you need to make three sections of chain, approximately 1.2 m long.And we put each one on its own hook.
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082817_13.jpg)
We bend
As a result, we do the same for all three.
Now we collect the ends of the chains into one hook.
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082757_17.jpg)
Like this:
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082750_18.jpg)
We bend and fix it.
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082791_20.jpg)
The part on the left is called a swivel, this is a swivel joint and it is needed so that the chain does not twist.
We put on the swivel.
We bend the hook.
We put on the threaded connector.
Then the carbine. It will be needed in the future so that the swing can be removed or hung at any time.
Now we measure the main chain, everything depends on the height to the branch of your tree. Cut off the required length.
We hang the chain with a reserve.
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082749_27.jpg)
We make a ring around the branch and connect both ends of the chain with a threaded connection - a screw carabiner.
Now you can use the carabiner to hang the swing.
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082826_29.jpg)
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082795_30.jpg)
The swing looks just great! They will definitely delight your kids, and while they are swinging, you can relax a little.
![Simple tire swing](https://i.washerhouse.com/uploads/posts/2018-04/1525082738_1.jpg)
Original article in English