Materials:
- Nylon tights
- Scissors
- Wire
- Beads
- Stack
- Threads
- Tape
Let's start:
To begin, we will make blanks for the flower; to do this, we cut off 25 centimeters of wire and wind it onto a stack, intertwining the ends with each other.
![make a ring](https://i.washerhouse.com/images/7/5-delaem-kolechko.jpg)
Cut out a piece of tights slightly larger than the blank. We place the wire ring on the tights and cover the workpiece with nylon.
![put it on the nylon](https://i.washerhouse.com/images/7/7-kladem-na-kapron.jpg)
![tie a petal](https://i.washerhouse.com/images/7/8-zavyazyvaem-lepestok.jpg)
We tie it with threads or wire quite tightly and trim the excess ends a little.
![tie it up](https://i.washerhouse.com/images/7/6-obvyazyvaem.jpg)
Using this principle, we make 4 more petals for one flower.
We make the middle from beads. To do this, cut the wire and string 4 beads, twist the wire and arrange the beads as shown in the photo.
![beads](https://i.washerhouse.com/images/7/9-businy.jpg)
We collect our flower, if necessary, bend the petals a little. We twist all the ends of the wire.
In principle, the flower is ready, all that remains is to decide what to do with it next. If you want to make a bouquet, you can wrap the wire with tape. If you want to make a brooch, then wrap the wire around a pin and cut off the excess wire at the end.
![Nylon flower](https://i.washerhouse.com/images/7/10-cvetok-iz-kaprona.jpg)
![Nylon flower](https://i.washerhouse.com/images/7/11-cvetok-iz-kaprona.jpg)