We will need:
* several LEGO bricks and plates for them
* candle or lighter for heating the tool
* matches
* knife (or medical scalpel)
* fine sandpaper on a block
* flash drive (preferably small)
* super glue based on cyanoacrylate (can be bought at a hardware store)
* remains of the previous building (if necessary)
* gloves (to protect against glue)
![Materials](https://i.washerhouse.com/images/1/454-materialy.jpg)
First you need to prepare a cube. If your flash drive is small, then you can use a 4X2 block; if it’s simple, then you’ll have to select another cube. Next, use a hot knife to make a neat hole for the USB connector.
![Cutting a hole](https://i.washerhouse.com/images/1/455-vyrezaem-otverstie.jpg)
It should be no larger and no smaller than the connector, otherwise the product will look ugly and the flash drive will dangle in the case.
![Finished hole](https://i.washerhouse.com/images/1/456-gotovoe-otverstie.jpg)
Through the hole we cut out some of the insides of the LEGO block so that there is room inside for the flash. If possible, you can finish it with a file, but do not process the product together with a flash drive, because this threatens to break the entire device.
![preparing the place for the connector](https://i.washerhouse.com/images/1/457-podgotavlivaem-mesto-dlya-razma.jpg)
![removing waste from the cube](https://i.washerhouse.com/images/1/458-udalyaem-othody-iz-kubika.jpg)
Afterwards, insert the flash drive into the cube and glue the plate into the bottom of the cube with a small amount of cyacrine to close the product.
![Insert the flash drive into the new case](https://i.washerhouse.com/images/1/459-vstavlyaem-fleshku-v-novyy-korpus.jpg)
If the flash drive is flat and falls into the USB port, then you can glue a lining from parts of the old case.
![Cutting out the lining from the old case](https://i.washerhouse.com/images/1/460-vyrezaem-podkladku-iz-starogo-korpusa.jpg)
![Glue the lining](https://i.washerhouse.com/images/1/461-prikleivaem-podklad.jpg)
That's all! The creative flash drive is ready!
![Ready product](https://i.washerhouse.com/images/1/462-gotovoe-izdelie.jpg)
![Flash drive case in LEGO style](https://i.washerhouse.com/images/1/463-korpus-dlya-fleshki-v-stile-LEGO.jpg)