![](https://i.washerhouse.com/_nw/4/65165630.jpg)
Aquest programador és un dels més senzills i comuns. Conté un mínim de detalls i és fàcil de repetir:
![](https://i.washerhouse.com/_nw/4/50754542.jpg)
Per al muntatge necessitem:
![](https://i.washerhouse.com/_nw/4/87054995.jpg)
Si no hi ha endoll al port COM, podeu tallar-lo des del joystick shogi:
![](https://i.washerhouse.com/_nw/4/96587213.jpg)
![](https://i.washerhouse.com/_nw/4/63335791.jpg)
Realització d'una placa de circuit imprès
![](https://i.washerhouse.com/_nw/4/35010219.jpg)
Ubicació de les peces:
![](https://i.washerhouse.com/_nw/4/11718487.jpg)
Per tant, el nostre tauler està llest, ara soldem les peces. Primer els saltadors, i després els detalls:
![](https://i.washerhouse.com/_nw/4/75697593.jpg)
Aquí totes les peces ja estan soldades i s'insereix el PIC16F628A MK
![](https://i.washerhouse.com/_nw/4/73113102.jpg)
L'etapa final: soldar el nostre cable COM. Però abans de soldar cal sonar
![](https://i.washerhouse.com/_nw/4/86166806.jpg)
És millor tallar els cables no utilitzats per evitar curtcircuits.
![](https://i.washerhouse.com/_nw/4/65165630.jpg)
![](https://i.washerhouse.com/_nw/4/92569083.jpg)